Enabling And Disabling Time Stamps On Log Messages; Enabling And Disabling Sequence Numbers In Log Messages - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 24
Configuring System Message Logging
Enabling and Disabling Time Stamps on Log Messages
By default, log messages are not time-stamped.
Beginning in privileged EXEC mode, follow these steps to enable time-stamping of log messages. This
procedure is optional.
Command
Step 1
configure terminal
Step 2
service timestamps log uptime
or
service timestamps log datetime [msec] [localtime]
[show-timezone]
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup-config
To disable time stamps for both debug and log messages, use the no service timestamps global
configuration command.
This example shows part of a logging display with the service timestamps log datetime global
configuration command enabled:
*Mar
This example shows part of a logging display with the service timestamps log uptime global
configuration command enabled:
00:00:46: %LINK-3-UPDOWN: Interface Port-channel1, changed state to up
Enabling and Disabling Sequence Numbers in Log Messages
Because there is a chance that more than one log message can have the same time stamp, you can display
messages with sequence numbers so that you can unambiguously see a single message. By default,
sequence numbers in log messages are not displayed.
Beginning in privileged EXEC mode, follow these steps to enable sequence numbers in log messages.
This procedure is optional.
Command
Step 1
configure terminal
Step 2
service sequence-numbers
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup-config
OL-8915-01
1 18:46:11: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Purpose
Enter global configuration mode.
Enable log time stamps.
The first command enables time stamps on log messages,
showing the time since the system was rebooted.
The second command enables time stamps on log messages.
Depending on the options selected, the time stamp can
include the date, time in milliseconds relative to the local
time-zone, and the time zone name.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enable sequence numbers.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring System Message Logging
24-7
Advertisement
Table of Contents
Troubleshooting
