Configuring Mstp Features; Default Mstp Configuration - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Configuring MSTP Features
•
•
Configuring MSTP Features
These sections contain this configuration information:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Default MSTP Configuration
Table 14-4
Table 14-4
Default MSTP Configuration
Feature
Spanning-tree mode
Switch priority (configurable on a per-CIST port basis)
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
14-14
Propagation—When an RSTP switch receives a TC message from another switch through a
designated or root port, it propagates the change to all of its nonedge, designated ports and to the
root port (excluding the port on which it is received). The switch starts the TC-while timer for all
such ports and flushes the information learned on them.
Protocol migration—For backward compatibility with IEEE 802.1D switches, RSTP selectively
sends IEEE 802.1D configuration BPDUs and TCN BPDUs on a per-port basis.
When a port is initialized, the migrate-delay timer is started (specifies the minimum time during
which RSTP BPDUs are sent), and RSTP BPDUs are sent. While this timer is active, the switch
processes all BPDUs received on that port and ignores the protocol type.
If the switch receives an IEEE 802.1D BPDU after the port migration-delay timer has expired, it
assumes that it is connected to an IEEE 802.1D switch and starts using only IEEE 802.1D BPDUs.
However, if the RSTP switch is using IEEE 802.1D BPDUs on a port and receives an RSTP BPDU
after the timer has expired, it restarts the timer and starts using RSTP BPDUs on that port.
Default MSTP Configuration, page 14-14
MSTP Configuration Guidelines, page 14-15
Specifying the MST Region Configuration and Enabling MSTP, page 14-16
Configuring the Root Switch, page 14-17
Configuring a Secondary Root Switch, page 14-18
Configuring Port Priority, page 14-19
Configuring Path Cost, page 14-20
Configuring the Switch Priority, page 14-21
Configuring the Hello Time, page 14-22
Configuring the Forwarding-Delay Time, page 14-23
Configuring the Maximum-Aging Time, page 14-23
Configuring the Maximum-Hop Count, page 14-24
Specifying the Link Type to Ensure Rapid Transitions, page 14-24
Designating the Neighbor Type, page 14-25
Restarting the Protocol Migration Process, page 14-25
shows the default MSTP configuration.
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
Default Setting
PVST+ (Rapid PVST+ and MSTP are disabled).
32768.
Chapter 14
Configuring MSTP
(required)
(optional)
OL-8915-01
Advertisement
Table of Contents
Troubleshooting
