Configuring The Priority Of Incoming Data Frames; Displaying Voice Vlan - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Displaying Voice VLAN
Configuring the Priority of Incoming Data Frames
You can connect a PC or other data device to a Cisco IP Phone port. To process tagged data traffic (in
IEEE 802.1Q or IEEE 802.1p frames), you can configure the switch to send CDP packets to instruct the
phone how to send data packets from the device attached to the access port on the Cisco IP Phone. The
PC can generate packets with an assigned CoS value. You can configure the phone to not change (trust)
or to override (not trust) the priority of frames arriving on the phone port from connected devices.
Beginning in privileged EXEC mode, follow these steps to set the priority of data traffic received from
the nonvoice port on the Cisco IP Phone:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
switchport priority extend
{cos value | trust}
Step 4
end
Step 5
show interfaces interface-id
switchport
Step 6
copy running-config
startup-config
This example shows how to configure a port connected to a Cisco IP Phone to not change the priority of
frames received from the PC or the attached device:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# switchport priority extend trust
Switch(config-if)# end
To return the port to its default setting, use the no switchport priority extend interface configuration
command.
Displaying Voice VLAN
To display voice VLAN configuration for an interface, use the show interfaces interface-id switchport
privileged EXEC command.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
12-6
Purpose
Enter global configuration mode.
Specify the interface connected to the Cisco IP Phone, and enter interface
configuration mode.
Set the priority of data traffic received from the Cisco IP Phone access port:
cos value—Configure the phone to override the priority received from the
•
PC or the attached device with the specified CoS value. The value is a
number from 0 to 7, with 7 as the highest priority. The default priority is
cos 0.
trust—Configure the phone access port to trust the priority received from
•
the PC or the attached device.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 12
End with CNTL/Z.
Configuring Voice VLAN
OL-8915-01
Advertisement
Table of Contents
Troubleshooting
