Default Vtp Configuration - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Configuring VTP
See the
you enable it. VTP pruning does not prune traffic from VLANs that are pruning-ineligible. VLAN 1 and
VLANs 1002 to 1005 are always pruning-ineligible; traffic from these VLANs cannot be pruned.
Extended-range VLANs (VLAN IDs higher than 1005) are also pruning-ineligible.
VTP pruning is not designed to function in VTP transparent mode. If one or more switches in the
network are in VTP transparent mode, you should do one of these:
•
•
To configure VTP pruning on an interface, use the switchport trunk pruning vlan interface
configuration command (see the
pruning operates when an interface is trunking. You can set VLAN pruning-eligibility, whether or not
VTP pruning is enabled for the VTP domain, whether or not any given VLAN exists, and whether or not
the interface is currently trunking.
Configuring VTP
These sections contain this configuration information:
•
•
•
•
•
•
•
•
•
Default VTP Configuration
Table 11-2
Table 11-2
Feature
VTP domain name
VTP mode
VTP version
VTP password
VTP pruning
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
11-6
"Enabling VTP Pruning" section on page
Turn off VTP pruning in the entire network.
Turn off VTP pruning by making all VLANs on the trunk of the switch upstream to the VTP
transparent switch pruning ineligible.
Default VTP Configuration, page 11-6
VTP Configuration Options, page 11-7
VTP Configuration Guidelines, page 11-8
Configuring a VTP Server, page 11-9
Configuring a VTP Client, page 11-11
Disabling VTP (VTP Transparent Mode), page 11-12
Enabling VTP Version 2, page 11-13
Enabling VTP Pruning, page 11-14
Adding a VTP Client Switch to a VTP Domain, page 11-14
shows the default VTP configuration.
Default VTP Configuration
11-14. VTP pruning takes effect several seconds after
"Changing the Pruning-Eligible List" section on page
Default Setting
Null.
Server.
Version 1 (Version 2 is disabled).
None.
Disabled.
Chapter 11
Configuring VTP
10-20). VTP
OL-8915-01
Advertisement
Table of Contents
Troubleshooting
