Table of Contents
Advertisement
Default Settings
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To configure IPS core dumps on the IPS module, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# ips core dump full
ips core dump full' successfully set for
module 9
switch(config)# no ips core dump full
ips core dump partial' successfully set for
module 9
Default Settings
Table 37-2
Table 37-2 Default Gigabit Ethernet Parameters
Parameters
IP MTU frame size
Auto-negotiation
Promiscuous mode
Cisco MDS 9000 Family Configuration Guide
37-20
lists the default settings for Gigabit Ethernet parameters.
Purpose
Enters configuration mode.
Configures a dump of the full core generation for
all IPS modules in the switch.
Configures a dump of the partial core generation
for the IPS module in slot 9.
Default
1500 bytes for all Ethernet ports
Enabled.
Disabled
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 37
Configuring IP Storage
Advertisement
Table of Contents
