Table of Contents
Advertisement
iSCSI Authentication Setup Guidelines and Scenarios
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
•
Figure 35-20 iSCSI Scenario 1
o.01.255891611111
01.25589167F74C
To configure scenario 1 (see
Configure null authentication for all iSCSI hosts in Cisco MDS switches.
Step 1
switch(config)# iscsi authentication none
Configure iSCSI to dynamically import all Fibre Channel targets into the iSCSI SAN using
Step 2
auto-generated iSCSI target names.
switch(config)# iscsi import target fc
Configure the Gigabit Ethernet interface in slot 7 port 1 with an IP address and enable the interface.
Step 3
switch(config)# int gigabitethernet 7/1
switch(config-if)# ip address 10.11.1.1 255.255.255.0
switch(config-if)# no shut
Note
Configure the iSCSI interface in slot 7 port 1 to identify all dynamic iSCSI initiators by the IP address,
Step 4
and enable the interface.
switch(config)# int iscsi 7/1
switch(config-if)# switchport initiator id ip-address
switch(config-if)# no shut
Configure the Gigabit Ethernet interface in slot 7 port 5 with the IP address and enable the interface.
Step 5
switch(config)# int gigabitethernet 7/5
switch(config-if)# ip address 10.15.1.1 255.255.255.0
switch(config-if)# no shut
Cisco MDS 9000 Family Configuration Guide
35-48
The iSCSI initiator host-2 with IP address 10.15.1.10 and node name
iqn.1987-05.com.cisco:01.25589167f74c connects to IPS port 7/5
7/1
Host 1
10.11.1.10
iSCSI
10.15.1.10
iSCSI
Host 2
7/5
Figure
Host 2 is connected to this port.
iSCSI-zone-1
Switch 1
iSCSI-zone-2
35-20), follow these steps:
Chapter 35
Configuring iSCSI
Interface fc 2/1
21:00:00:20:37:6f:fd:97
Interface fc 2/5
21:00:00:20:37:6f:fe:54
Interface fc 2/9
21:00:00:20:37:a6:a6:5d
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
