Table of Contents
Advertisement
IPFC Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
IPFC Configuration Example
This section describe an example configuration for IPFC.
The example network has the following links:
•
•
Figure 36-3
IP address: 10.1.1.3
IP subnet: 255.0.0.0
The following steps show how to configure Switch_1 in the example network in
Create the VSAN interface and enter interface configuration submode.
Step 1
switch_1# config t
switch_1(config)# interface vsan 1
switch_1(config-if)#
Step 2
Configure the IP address and subnet mask.
switch_1(config-if)# ip address 10.1.1.1 255.0.0.0
Enable the VSAN interface and exit interface configuration submode.
Step 3
switch_1(config-if)# no shutdown
switch_1(config-if)# exit
switch_1(config)#
Cisco MDS 9000 Family Configuration Guide
36-6
Switch_1 is connected to the main network by the mgmt 0 interface and to the fabric by an ISL.
Switch_2 and Switch_3 are connected to the fabric by an ISL but are not connected to the main
network.
IPFC Example Network
Switch_3
Figure 36-3
Switch_1
IP address: 10.1.1.1
IP subnet: 255.0.0.0
Switch_2
Chapter 36
Configuring IP Services
shows an example network.
IP address: 10.1.1.2
IP subnet: 255.0.0.0
Figure
36-3:
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
