hit counter script

Default Gigabit Ethernet Configuration; Configuring Gigabit Ethernet - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Software guide
Table of Contents

Advertisement

Default Gigabit Ethernet Configuration

Default Gigabit Ethernet Configuration
Table 5-7
Table 5-7
Feature
Port enable state
Port name
Port priority
Duplex mode
Flow control
Port negotiation
Spanning Tree Protocol Enabled for VLAN 1
Native VLAN
Spanning tree port cost
Gigabit EtherChannel

Configuring Gigabit Ethernet

These sections describe how to configure Gigabit Ethernet switching ports on the Catalyst enterprise
LAN switches:
Note
For information on configuring Gigabit EtherChannel, see
and Gigabit EtherChannel."
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
5-6
shows the Gigabit Ethernet default configuration.
Gigabit Ethernet Default Configuration
Default Value
All ports are enabled
None
Normal
Full duplex
Enabled
VLAN 1
4
Disabled on all Gigabit Ethernet ports (auto mode)
Setting the Port Name, page 5-7
Setting the Port Priority Level, page 5-7
Configuring Flow Control on Gigabit Ethernet Ports, page 5-8
Configuring Port Negotiation on Gigabit Ethernet Ports, page 5-8
Configuring a Timeout Period for Ports in errdisable State, page 5-9
Checking Connectivity, page 5-9
Oversubscribed Gigabit Ethernet ports (ports 3–18 on WS-X4418-GB):
Flow control set to desired for receive (Rx) and on for transmit (Tx)
All others: Flow control set to off for receive (Rx) and desired for
transmit (Tx)
Chapter 5
Configuring Gigabit Ethernet Switching
Chapter 6, "Configuring Fast EtherChannel
78-12647-02

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 4000 seriesCatalyst 2948gCatalyst 2980g

Table of Contents