How To Use The Fax Function; Sending Originals; Setting The Original - Sharp ARFX13 - Fax Interface Card Operation Manual

Facsimile expansion kit

Hide thumbs Also See for ARFX13 - Fax Interface Card:

Table of Contents

Chapter 4

HOW TO USE THE FAX FUNCTION

The stand alone fax component of your machine offers a range of sophisticated features that allow you to control

image quality, reception mode, broadcasting, polling, and transmission priorities. Functions such as sending

original(s) from memory and substituting reception into memory are possible, due to the large memory capacity.

This section describes setting original(s) in the RSPF or on the document glass.

When Using the RSPF:

Confirm that there are no original(s)

on the document glass and that

copying is not in progress, then

gently close the RSPF.

Adjust the original guides to the width

of your original(s).

Place the original(s) face up and push

it gently into the document feeder

tray. The top edge of the original(s)

should enter the fax first.

Original face up

There are two ways to send the fax:

• To scan the original into memory, then dial and

transmit, continue with the "DIALING AND

TRANSMITTING" section. (p.58)

• To dial and transmit the original directly without

first scanning it into memory, press the

[MEMORY] key to make the [MEMORY] key

indicator go off. Continue with the "DIALING

AND TRANSMITTING" section. (p.58)

Table of Contents