Table of Contents
Advertisement
INITIAL SETTINGS
9
Enter the name of the destination with
the numeric keys.
10
Press the [OK] key.
1,2,3,
1,2,3,
SP. FUNC
11
Press the [
] key (
to select a Chain Dial setting.
1,2,3,
1,2,3,
SP. FUNC
If the number is not set as a chain dial number,
the communication speed and international
communication mode cannot be selected. Press
the [OK] key and go to step 18.
12
Press the [OK] key.
13
Press the [
] key (
to select the communication speed.
1,2,3,
1,2,3,
SP. FUNC
For international dialing, if you find that line
Note
noise necessitates a slower transmission
speed, set the appropriate transmission
speed. If you are not sure if a slower speed
is required, set the speed normally.
42
Enter the name of the
location or party by
pressing numeric keys as
described in "HOW TO
ENTER CHARACTERS"
on page 20 (maximum of
20 characters). If you do
not want to enter a name,
skip this step.
) or [
] key (
)
If you wish to set the
number as a Chain Dial
number, select "1:SET".
Otherwise, select
"2:CANCEL".
(See "CHAIN DIALING"
(p.59))
) or [
] key (
)
The selections are as
follows:
1:33600bps
2:14400bps
3:9600bps
4:4800bps
14
Press the [OK] key.
15
Press the [
] key (
to select the international
communication mode.
1,2,3,
1,2,3,
SP. FUNC
Sometimes when faxing internationally, line
Note
noise can cause the transmission to stop
momentarily. To reduce these delays, please
intially select mode 1, if still unsuccessful
then try mode 2, and if still not successful,
try mode 3 which is combination of the first
two modes.
16
Press the [OK] key.
1,2,3,
1,2,3,
SP. FUNC
17
Press the [MENU] key.
1,2,3,
1,2,3,
SP. FUNC
You may need to add a pause between
Note
certain digits in the number to allow time for
connection. For example, if you are on a
PBX telephone system that requires an
access number, such as "9", to be dialed to
access an outside line, you will need to
enter a pause between the access number
and the fax number of the other party.
Pauses are entered by pressing the
[REDIAL/PAUSE] key (2 seconds per
pause). If necessary, several pauses can be
entered in a row.
) or [
] key (
)
The selections are as
follows:
1:NO
2:MODE 1
3:MODE 2
4:MODE 3
Return to Step 5 to store
another number.
Press the [MENU] key a
number of times until you
exit.
If the number is a Rapid
key number, you can
write the name on the
label above the
appropriate Rapid key.
Advertisement
Table of Contents
Troubleshooting
