Table of Contents
Advertisement
Removing and Replacing the CompactFlash
Removing and Installing the User CompactFlash
To remove and install the user CompactFlash, perform the following steps:
There are two types of CompactFlash release buttons. The release buttons function differently. In this
Note
document we refer to them as Type A and Type B
Locate the user CompactFlash in its slot in the rear panel of the chassis. See
Step 1
Figure 4-13
2
1
Step 2
Press the release button, the release button in Type A will pop out towards you. See
In Type B pressing the release button once will eject the CompactFlash, the release button will be slightly
extended. See
Figure 4-14
2
1
Cisco ASA 5500 Series Hardware Installation Guide
4-12
User CompactFlash and Release Button Location—Type A and B
1
F L A S H
User CompactFlash in the slot
Figure
4-15. If this is the case, skip Step 3 and go to
Release Button Fully Extended—Type A
1
F L A S H
User CompactFlash in the slot
Chapter 4
.
2
Release button extended
2
Release button fully extended
Maintenance and Upgrade Procedures
Figure
4-13.
Figure
4-14.
Step
4.
78-17989-01
Hide quick links:
Advertisement
Table of Contents
