Table of Contents
Advertisement
Installing and Replacing the 4GE SSM
Step 5
Attach the screws to secure the 4GE SSM to the chassis.
Power on the adaptive security appliance.
Step 6
Check the LEDs. If the 4GE SSM is installed properly the STATUS LED flashes during boot up and is
Step 7
solid when operational.
Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices.
Step 8
Replacing the 4GE SSM
To replace an existing 4GE SSM, perform the following steps:
Power off the adaptive security appliance.
Step 1
Step 2
Locate the grounding strap from the accessory kit and fasten it to your wrist, so that it contacts your bare
skin. Attach the other end to the chassis.
Step 3
Remove the two screws at the left rear end of the chassis.
Remove the 4GE SSM. Place it in a static bag and set it aside.
Step 4
Step 5
Replace the existing card by inserting the new 4GE SSM through the slot opening.
Attach the screws to secure the 4GE SSM to the chassis.
Step 6
Step 7
Power on the adaptive security appliance.
Check the LEDs. If the 4GE SSM is installed properly, the POWER LED is solid green and the STATUS
Step 8
LED is flashing during boot up.
Connect the RJ-45 cable to the port and the other end of the cable to your network devices.
Step 9
Installing and Removing the SFP Modules
The SFP is a hot-swappable input/output device that plugs into the SFP ports. The following SFP module
types are supported:
•
•
This section describes how to install and remove the SFP modules in the adaptive security appliance to
provide optical Gigabit Ethernet connectivity. It contains the following topics:
•
•
•
SFP Module
The adaptive security appliance uses a field-replaceable SFP module to establish Gigabit connections.
Table 4-2
Cisco ASA 5500 Series Hardware Installation Guide
4-16
Long wavelength/long haul 1000BASE-LX/LH (GLC-LH-SM=)
Short wavelength 1000BASE-SX (GLC-SX-MM=)
SFP Module, page 4-16
Installing the SFP Module, page 4-18
Removing the SFP Module, page 4-19
lists the SFP modules that are supported by the adaptive security appliance.
Chapter 4
Maintenance and Upgrade Procedures
78-17989-01
Hide quick links:
Advertisement
Table of Contents
