Safety Recommendations
Step 2
Read the release notes for the respective software version.
Unpack the chassis. An accessory kit ships with the chassis and includes the following items:
Step 3
documentation, a product CD, a power cord (AC models only), two RJ-45 Ethernet cables, one RJ-45 to
DB-9 console cable, a rack-mounting kit, and four self-adhesive feet (for desktop mounting).
Step 4
Place the chassis on a stable work surface.
Safety Recommendations
Use the following guidelines and the information in the following sections to help ensure your safety and
protect the adaptive security appliance. The list of guidelines may not address all potentially hazardous
situations in your working environment, so be alert and exercise good judgement at all times.
If you need to remove the chassis cover to install a hardware component, such as additional memory or
Note
an interface card, doing so does not affect your Cisco warranty. Upgrading the adaptive security
appliance does not require any special tools and does not create any radio frequency leaks.
The safety guidelines are as follows:
•
•
•
•
•
•
This section includes the following topics:
•
•
Maintaining Safety with Electricity
Before working on a chassis or working near power supplies, unplug the power cord on AC units;
Warning
disconnect the power at the circuit breaker on DC units. Statement 12
Follow these guidelines when working on equipment powered by electricity:
•
•
•
Cisco ASA 5500 Series Hardware Installation Guide
2-2
Keep the chassis area clear and dust-free before, during and after installation.
Keep tools away from walk areas where you and others could fall over them.
Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains, that could get caught
in the chassis.
Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Never attempt to lift an object that is too heavy for one person to handle.
Maintaining Safety with Electricity, page 2-2
Preventing Electrostatic Discharge Damage, page 2-3
Before beginning procedures that require access to the interior of the chassis, locate the emergency
power-off switch for the room in which you are working. Then, if an electrical accident occurs, you
can act quickly to turn off the power.
Do not work alone if potentially hazardous conditions exist anywhere in your work space.
Never assume that power is disconnected from a circuit; always check the circuit.
Chapter 2
Preparing for Installation
78-17989-01