Table of Contents
Advertisement
Installing the Adaptive Security Appliance
Figure 3-4
1
Place the chassis right-side up on a flat, smooth, secure surface.
Step 4
Step 5
Connect the interface cables. See the
information.
Connecting the Interface Cables
This section describes how to connect the cables to the Console, Management, 4GE SSM, and SSM ports.
In this document, SSM refers to an intelligent SSM, the AIP SSM or CSC SSM.
You can use any unused Ethernet interface on the device as the failover link. The failover link interface
Note
is not configured as a normal networking interface; it should only be used for the failover link. You can
connect the LAN-based failover link by using a dedicated switch with no hosts or routers on the link or
by using a crossover Ethernet cable to link the units directly. For more information, see the Cisco Security
Appliance Command Line Configuration Guide.
Only trained and qualified personnel should install, replace, or service this equipment
Warning
Caution
Read the safety warnings in the Regulatory Compliance and Safety Information for the Cisco ASA 5505
Adaptive Security Appliance and follow proper safety procedures when performing these steps.
Cisco ASA 5500 Series Hardware Installation Guide
3-4
Attaching the Rubber Feet
1
Rubber feet
Chapter 3
"Connecting the Interface Cables" section on page 3-4
Installing the Adaptive Security Appliance
for more
Statement 49
.
78-17989-01
Hide quick links:
Advertisement
Table of Contents
