VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
Do not change the specification of this appliance. • The operating water pressure (minimum and maximum) must be • between 0.5 (0.05) / 8 (0.8) bar (MPa) Follow the maximum number of 13 place settings. • If the supply cord is damaged, it must be replaced by the •...
cable need to be replaced, this must be carried • Please note that self-repair or non-professional out by our Authorised Service Centre. repair can have safety consequences and might • Connect the mains plug to the mains socket void the guarantee. only at the end of the installation.
Upper spray arm Rinse aid dispenser Lower spray arm Detergent dispenser Filters Cutlery basket Rating plate Lower basket Salt container Upper basket Air vent CONTROL PANEL On/off button / Reset button Programme button Programme indicators Delay button Indicators...
Page 6
INDICATORS Indicator Description Drying phase indicator. It is on when you select a programme with the drying phase. It flashes when the drying phase operates. Salt indicator. It is on when the salt container needs refilling. It is always off while the programme operates.
CONSUMPTION VALUES Water Energy Duration 1) 2) Programme (kWh) (min) 1.036 11.1 - 13.6 1.052 - 1.285 9.6 - 11.7 0.886 - 1.083 9.2 - 11.2 0.556 - 0.680 3.4 - 4.2 0.012 - 0.015 1) The pressure and the temperature of the water, the variations of the mains supply, the options, the quan- tity of dishes and the degree of soil can change the values.
Each performed softener rinse (possible more than 2. Wait until the indicator continues to flash one in the same cycle) may prolong the programme and the remaining programme indicators are duration by another 5 minutes when it occurs at any off.
CAUTION! If children have access to the appliance, it is advised to deactivate AirDry as opening the door may pose a danger. How to deactivate the AirDry Make sure the appliance is in user mode. 1. Press the programme button three times. The indicator starts to flash.
CAUTION! The compartment (A) is for rinse aid only. Do not fill it with detergent. CAUTION! Only use rinse aid designed specifically for dishwashers. 1. Press the release button (D) to open the lid 6. Turn the cap of the salt container clockwise to (C).
2. Put the detergent, in powder or tablets, in the consumption and the programme duration. After compartment (A). closing the door, the appliance continues from the 3. If the programme has a prewash phase, put a point of interruption. small quantity of detergent on the inner part of the appliance door.
Page 13
arrange items in the baskets as instructed in the • Always use the correct quantity of rinse aid. user manual and do not overload the baskets. Insufficient dosage of rinse aid decreases the • Do not pre-rinse dishes by hand. It increases drying results.
• The programme is suitable to the type of load 2. First remove items from the lower basket, then and the degree of soil. from the upper basket. • The correct quantity of detergent is used. After the programme is completed, water can still remain on the inside UNLOADING THE BASKETS surfaces of the appliance.
2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. CLEANING THE LOWER SPRAY ARM We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes.
3. To install the spray arm back, press it CLEANING THE UPPER SPRAY ARM downwards. Do not remove the upper spray arm. If the openings in the spray arm are clogged, remove the remaining particles of soil with a thin pointed object, e.g. a toothpick.
Page 17
Problem and alarm code Possible cause and solution The appliance does not drain the water. • Make sure that the sink spigot is not clogged. • Make sure that the interior filter system is not clog- • The indicator flashes 2 times in- ged.
Page 18
Problem and alarm code Possible cause and solution The programme lasts too long. • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. • Refer to the consumption values table in the chapter "Programmes".
Page 19
Problem Possible cause and solution Poor drying results. • Tableware has been left for too long inside the closed appli- ance. • There is no rinse aid or the dosage of rinse aid is not suffi- cient. Fill the rinse aid dispenser or set the dosage of rinse aid to a higher level.
Problem Possible cause and solution Limescale deposits on the table- • The level of salt is low, check the refill indicator. ware, on the tub and on the in- • The cap of the salt container is loose. side of the door. •...
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it. Help contact your municipal office. protect the environment and human health by recycling waste of electrical and electronic appliances.