Changing Gear Oil - Yamaha F75 Owner's Manual
Hide thumbs
Also See for F75:
- Owner's manual (104 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
Available languages
Available languages
5. Propeller
6. Thrust washer
Propeller nut tightening torque:
34 Nm (3.47 kgf-m, 25.1 ft-lb)
4.
Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTICE: Do not reuse the cotter pin.
Otherwise, the propeller can come off
during operation.
TIP:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, tighten the nut further to
align it with the hole.
EMU2928C
Changing gear oil
EWM00801
WARNING
Be sure the outboard motor is securely
fastened to the transom or a stable
stand. You could be severely injured if
the outboard motor falls on you.
Never get under the lower unit while it is
tilted, even when the tilt support lever or
knob is locked. Severe injury could oc-
cur if the outboard motor accidentally
falls.
[ECM01892]
ZMU02063
1.
Tilt the outboard motor so that the gear
oil drain screw is at the lowest point pos-
sible.
2.
Place a suitable container under the gear
case.
3.
Remove the gear oil drain screw and
gasket. NOTICE: If there is an exces-
sive quantity of metal particles on the
magnetic gear oil drain screw, this
can indicate lower unit problem. Con-
sult your Yamaha dealer.
1. Gear oil drain screw
2. Oil level plug
TIP:
If a magnetic gear oil drain screw is
equipped, remove all metal particles from
the screw before installing it.
Always use new gaskets. Do not reuse the
removed gaskets.
4.
Remove the oil level plug and gasket to
allow the oil to drain completely.
NOTICE: Check the used gear oil after
it has been drained. If the gear oil is
milky or contains water or a large
amount of metal particles, the gear
case may be damaged. Have a
Yamaha dealer check and repair the
outboard motor.
TIP:
For disposal of used oil, consult your Yamaha
dealer.
Maintenance
[ECM01901]
2
1
ZMU03273
[ECM00714]
85
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
