Controls; Engine Shut-Off Cord (Lanyard); Engine Oil - Yamaha F75 Owner's Manual
Hide thumbs
Also See for F75:
- Owner's manual (104 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
Available languages
Available languages
EMU36903
Controls
Tiller handle models:
Move the tiller handle fully to the left and
right to make sure operation is smooth.
Turn the throttle grip from the fully closed
to the fully open position. Make sure that it
turns smoothly and that it completely re-
turns to the fully closed position.
Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
Look for loose or damaged connections of
the throttle and shift cables.
EMU36484
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
1. Clip
2. Engine shut-off cord (lanyard)
1
2
ZMU06873
EMU40994
Engine oil
1.
Place the outboard motor in a vertical
position (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
2.
Remove the oil dipstick and wipe it
clean.
1. Oil dipstick
3.
Insert the oil dipstick completely and re-
move it again.
4.
Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil lev-
el is not at the proper level or if it appears
milky or dirty.
1. Lower mark
2. Oil dipstick
3. Upper mark
Operation
1
ZMU05368
51
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
