Starter Will Not Operate - Yamaha F75 Owner's Manual
Hide thumbs
Also See for F75:
- Owner's manual (104 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
Available languages
Available languages
1. Filter cup
2. Water detection switch lead
6.
Drain the water in the filter cup by soak-
ing it up with a rag.
7.
Firmly screw the filter cup onto the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when screwing the filter cup onto the
filter housing.
8.
Connect the water detection switch cou-
pler securely until a click is heard.
1. Water detection switch coupler
9.
Fasten the water detection switch lead
with the plastic tie.
[ECM01971]
Trouble Recovery
1. Plastic tie
10. Install the top cowling.
11. Start the engine and make sure that the
water separator-alert indicator remains
off. Have a Yamaha dealer inspect the
outboard motor after returning to port.
EMU29543
Starter will not operate
If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started manually with
an emergency starter rope. However, the en-
gine cannot be started manually if the battery
voltage is low. If the battery is discharged to
9 volts or below, the electric fuel pump will
not operate.
EWM01023
WARNING
Use this procedure only in an emergen-
cy to return to the nearest port for re-
pairs.
When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
95
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
