Cisco Nexus 93180YC-FX3 Installation Manual page 46

Aci-mode switch

Hide thumbs Also See for Nexus 93180YC-FX3:

Table of Contents

Replacing an AC Power Supply

Step 1

Remove an AC power supply as follows:

a) Holding the plug for the power cable, pull the plug out from the power receptacle on the power supply and verify

that both power supply LEDs are off.

b) Grasp the power supply handle while pressing the colored release latch towards the power supply handle.

c) Place your other hand under the power supply to support it while you slide it out of the chassis.

Do not touch the electrical connections on the back side of the module and prevent anything else from

Caution

coming into contact with and damaging the connectors.

Step 2

Install the replacement power supply as follows:

a) Holding the replacement power supply with one hand underneath the module and the other hand holding the handle,

turn the power supply so that its release latch is on the right side and align the back end of the power supply (the end

with the electrical connections) to the open power supply slot before carefully sliding the power supply all the way

into the slot until it clicks into place.

Note

If the power supply does not fit into the open slot, turn the module over before sliding it carefully into the

open slot.

b) Test the installation by trying to pull the power supply out of the slot without using the release latch.

If the power supply does not move out of place, it is secured in the slot. If the power supply moves, carefully press

it all the way into the slot until it clicks in place.

c) Attach the power cable to the electrical outlet on the front of the power supply.

d) Make sure that the other end of the power cable is attached to the appropriate power source for the power supply.

Depending on the outlet receptacle on your power distribution unit, you might need the optional jumper

Note

cable to connect the switch to your outlet receptacle.

e) Verify that the power supply is operational by making sure that the power supply LED is green.

Cisco Nexus 93180YC-FX3 ACI-Mode Switch Hardware Installation Guide

Replacing Components

Table of Contents

Chapters

Table of Contents

N9k-c93180yc-fx3