Cisco Nexus 93180YC-FX3 Installation Manual page 28

Aci-mode switch

Hide thumbs Also See for Nexus 93180YC-FX3:

Table of Contents

Installing the Switch Using the N3K-C3064-ACC-KIT Rack-Mount Kit

Step 3

If you are not installing the chassis into a grounded rack, you must attach a customer-supplied grounding wire to the

chassis as explained in the

rack, you can skip this step.

Step 4

Install the slider rails on the rack or cabinet as follows:

a) Determine which two posts of the rack or cabinet you should use for the slider rails. Of the four vertical posts in the

rack or cabinet, two will be used for the front mount brackets attached to the easiest accessed end of the chassis, and

the other two posts will have the slider rails.

b) Position a slider rail at the desired level on the back side of the rack and use two 12-24 screws or two 10-32 screws,

depending on the rack thread type, to attach the rails to the rack (see the following figure). Tighten 12-24 screws to

30 in-lb (3.39 N·m) of torque and tighten 10-32 screws to 20 in-lb (2.26 N·m) of torque.

Slider rail with screw holes aligned to screw holes in

rack

c) Repeat Step 3 to attach the other slider rail to the other side of the rack.

To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count

the screw holes in the vertical mounting rails.

Step 5

Insert the switch into the rack and attach it as follows:

a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or

cabinet posts that do not have slider rails attached to them (see the following figure).

Cisco Nexus 93180YC-FX3 ACI-Mode Switch Hardware Installation Guide

Grounding the Chassis, on page 24

section.. If you are installing the chassis into a grounded

Two customer-supplied 12-24 or 10-32 screws used

to attach each slider rail to the rack

Installing the Switch Chassis

Table of Contents

Chapters

Table of Contents

N9k-c93180yc-fx3