Cisco Nexus 93180YC-FX3 Installation Manual page 27

Aci-mode switch

Hide thumbs Also See for Nexus 93180YC-FX3:

Table of Contents

Installing the Switch Chassis

Front rack-mount bracket aligned to the port end of

the chassis

Four M4 screws used to attach the bracket to the

chassis

Rear rack-mount guide aligned to the module end of

the chassis

Two M4 screws used to attach the bracket to the

chassis

c) Secure the front-mount bracket to the chassis using four M4 screws and tighten each screw to 12 in-lb (1.36 N·m)

of torque.

d) Repeat Step 1 for the other front rack-mount bracket on the other side of the switch and be sure to position that bracket

the same distance from the front of the switch.

Step 2

Install the two rear rack-mount brackets on the chassis as follows:

a) Align the two screw holes on a rear rack-mount bracket to the middle two screw holes in the remaining six screw

holes on a side of the chassis. If you are aligning the guide to holes that are near the port connections end of the

chassis, see Callout 3 in the previous figure. Otherwise, see Callout 7 in the previous figure.

b) Attach the guide to the chassis using two M4 screws (see Callout 4 or 8 in the previous figure). Tighten the screws

to 12 in-lb (1.36 N·m) of torque.

c) Repeat Step 2 for the other rear rack-mount bracket on the other side of the switch.

Installing the Switch Using the N3K-C3064-ACC-KIT Rack-Mount Kit

Front rack-mount bracket aligned to the module end

of the chassis

Four M4 screws used to attach the bracket to the

chassis

Two M4 screws used to attach the bracket to the

chassis

Rear rack-mount guide aligned to the port end of the

chassis

Cisco Nexus 93180YC-FX3 ACI-Mode Switch Hardware Installation Guide

Table of Contents

Chapters

Table of Contents

N9k-c93180yc-fx3