Table of Contents
Advertisement
Removing a Port Adapter
Note
router when removing and replacing a PA-T3 port adapter.
When a port adapter slot is not in use, blank port adapters must fill empty slots to allow the router to
conform to EMI emissions requirements and to allow proper airflow across the port adapters. If you
plan to install a new port adapter in a slot that is not in use, you must first remove the blank port
adapter.
Removing a Port Adapter
Following is the procedure for removing a port adapter from a Cisco uBR7200 series router:
Step 1
Step 2
Figure 6-2
6-2
PA-T3 Serial Port Adapter Installation and Configuration
Cisco uBR7200 series routers support OIR; therefore, you do not have to power down the
Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
Place the port adapter retention clips or levers in the unlocked position:
•
For a Cisco uBR7246, place the port adapter retention clip for the desired port adapter
slot in the unlocked position. The retention clip remains in the unlocked position.
(See Figure 6-2.)
Placing the Port Adapter Retention Clip in the Unlocked
Position—Cisco uBR7246
Port adapters
•
For a Cisco uBR7223, place the port adapter lever in the unlocked position.
(See Figure 6-3.)
Port adapter
retention clip in
unlocked position
Advertisement
Table of Contents
