Table of Contents
Advertisement
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing
the PA-T3 port adapters.
•
Parts and Tools Required, page 2-1
•
Software and Hardware Requirements, page 2-2
•
PA-T3 Port Adapter LEDs, page 2-3
•
PA-T3 Receptacles and Cables, page 2-5
•
•
Safety Guidelines, page 2-6
•
FCC Class A Compliance, page 2-8
Parts and Tools Required
You need the following tools and parts to install a port adapter. If you need additional equipment,
contact a service representative for ordering information.
•
PA-T3 serial port adapter and one of the following:
- VIP2-15(=), VIP2-20=, VIP2-40(=), or VIP2-50(=) motherboard
- Catalyst RSM/VIP2-15(=) or Catalyst RSM/VIP2-40(=) motherboard
- Cisco 7100 series router with at least one available port adapter slot
- Cisco 7200 series router with at least one available port adapter slot
- Cisco uBR7200 series router with at least one available port adapter slot
•
75-ohm coaxial serial interface cables
•
Number 1 Phillips screwdriver and a 3/16-inch flat-blade screwdriver
•
Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, field-replaceable units (FRUs), and spares
C H A P T E R
2
Advertisement
Table of Contents
