Table of Contents
Advertisement
Figure 3-4
Step 7
This completes the procedure for removing a new port adapter on a VIP2.
Installing a Port Adapter
Following is the standard procedure for installing a port adapter on the VIP2.
Step 1
Step 2
Figure 3-5
Aligning a Port Adapter in a Port Adapter Slot
Pulling a Port Adapter Out of a Slot—Partial Port Adapter View
If you removed a port adapter, place it in an antistatic container for safe storage or
shipment back to the factory. If you removed a blank port adapter, no special handling is
required; however, store the blank port adapter for potential future use.
Remove the new port adapter from its antistatic container and position it at the opening
of the slot.
Carefully align the port adapter carrier between the upper and the lower edges of the port
adapter slot, as shown in Figure 3-5.
Carrier
Upper edge
Lower edge
Installing a Port Adapter
VIP2 and the PA-T3 Port Adapter 3-5
Advertisement
Table of Contents
