Cisco Catalyst 9500 Manual page 298
Hide thumbs
Also See for Catalyst 9500:
- Manual (360 pages) ,
- Configuration manual (223 pages) ,
- Hardware installation manual (122 pages)
Table of Contents
Advertisement
Configuring OBFL
Configuring OBFL
Caution
We recommend that you do not disable OBFL and that you do not remove the data stored in the flash memory.
•
• To enable OBFL, use the hw-switch switch [switch-number] logging onboard [message level level]
• To copy the OBFL data to the local network or a specific file system, use the copy onboard switch
• To disable OBFL, use the no hw-switch switch [switch-number] logging onboard [message level]
• To clear all the OBFL data in the flash memory except for the uptime and CLI command information,
• In a switch stack, you can enable OBFL on a standalone switch or on all stack members by using the
• The following does not apply to the C9500-12Q, C9500-16X, C9500-24Q, C9500-40X models of the
For more information about the commands in this section, see the command reference for this release.
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
284
global configuration command. On switches, the range for switch-number is from 1 to 9. Use the message
level level parameter to specify the severity of the hardware-related messages that the switch generates
and stores in the flash memory.
The following applies to the C9500-12Q, C9500-16X, C9500-24Q, C9500-40X models of the Cisco
Catalyst 9500 Series Switches. To enable OBFL, use the hw-switch switch [module-number] logging
onboard {application-name } global configuration command.
switch-number url url-destination privileged EXEC command.
Note
This does not apply to the C9500-12Q, C9500-16X, C9500-24Q, C9500-40X
models of the Cisco Catalyst 9500 Series Switches.
global configuration command.
The following applies to the C9500-12Q, C9500-16X, C9500-24Q, C9500-40X models of the Cisco
Catalyst 9500 Series Switches. To disable OBFL, use the no hw-module slot [module-number] logging
onboard {application-name } global configuration command.
use the clear onboard switch switch-number privileged EXEC command.
The following applies to the C9500-12Q, C9500-16X, C9500-24Q, C9500-40X models of the Cisco
Catalyst 9500 Series Switches. To disable OBFL, use the no hw-module slot [module-number] logging
onboard {application-name } global configuration command.
To clear all the OBFL data in the flash memory except for the uptime, use the clear logging onboard
RP active {application} privileged EXEC command.
hw-switch switch [switch-number] logging onboard [message level level] global configuration command.
Cisco Catalyst 9500 Series Switches. To disable OBFL, use the no hw-module slot [module-number]
logging onboard {application-name } global configuration command.
You can enable or disable OBFL on a member switch from the active switch.
Troubleshooting the Software Configuration
Hide quick links:
Advertisement
Table of Contents
