Monitoring Application Visibility And Control; Examples: Application Visibility And Control Configuration - Cisco Catalyst 9500 Manual
Hide thumbs
Also See for Catalyst 9500:
- Manual (360 pages) ,
- Configuration manual (223 pages) ,
- Hardware installation manual (122 pages)
Table of Contents
Advertisement
Configuring Application Visibility and Control in a Wired Network
Monitoring Application Visibility and Control
This section describes the new commands for application visibility.
The following commands can be used to monitor application visibility on the switch and access ports.
Table 10: Monitoring Application Visibility Commands on the Switch
Command
show ip nbar protocol-discovery [interface
interface-type interface-number]
[stats{byte-count | bit-rate | packet-count
| max-bit-rate}] [protocol protocol-name
| top-n number]
show policy-map interface interface-type
interface-number
show platform software fed switch switch id
wdavc flows
Examples: Application Visibility and Control Configuration
This example shows how to create class maps with apply match protocol filters for application name:
Device# configure terminal
Device(config)# class-map match-any NBAR-VOICE
Device(config-cmap)# match protocol ms-lync-audio
Device(config-cmap)#end
This example shows how to create policy maps and define existing class maps for egress QoS:
Device # configure terminal
Device(config)# policy-map test-avc-up
Device(config-pmap)# class cat-browsing
Device(config-pmap-c)# police 150000
Device(config-pmap-c)# set dscp 12
Device(config-pmap-c)#end
This example shows how to create policy maps and define existing class maps for ingress QoS:
Device# configure terminal
Device(config)# policy-map test-avc-down
Device(config-pmap)# class cat-browsing
Device(config-pmap-c)# police 200000
Device(config-pmap-c)# set dscp 10
Device(config-pmap-c)#end
This example shows how to apply policy maps to a switch port:
Device# configure terminal
Device(config)# interface GigabitEthernet 1/0/1
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Monitoring Application Visibility and Control
Purpose
Displays the statistics gathered by the NBAR Protocol
Discovery feature.
• (Optional) Enter keywords and arguments to fine-tune
the statistics displayed. For more information on each
of the keywords, refer to the show ip nbar
protocol-discoverycommand in Cisco IOS Quality
of Service Solutions Command Reference.
Displays information about policy map applied to the
interface.
Displays statistics about all flows on the specified switch.
131
Hide quick links:
Advertisement
Table of Contents
