Configuring Online Diagnostics
Command
show diagnostic result switch [number | all] [detail | test
{name | test-id | test-id-range | all} [detail]]
show diagnostic switch [number | all] [detail]
The below command applies to the C9500-12Q, C9500-16X,
C9500-24Q, C9500-40X models of the Cisco Catalyst 9500
Series Switches.
show diagnostic detail]
show diagnostic schedule [number | all]
show diagnostic post
The below command applies to the C9500-12Q, C9500-16X,
C9500-24Q, C9500-40X models of the Cisco Catalyst 9500
Series Switches.
show post
show diagnostic events {event-type | module}
show diagnostic description module [number] test { name
| test-id | all }
Configuration Examples for Online Diagnostics
The following sections provide examples of online diagnostics configurations.
Examples: Start Diagnostic Tests
This example shows how to start a diagnostic test by using the test name:
Device#
diagnostic start switch 2 test DiagFanTest
This example shows how to start all of the basic diagnostic tests:
Device# diagnostic start switch 1 test all
Example: Configure a Health-Monitoring Test
This example shows how to configure a health-monitoring test:
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Configuration Examples for Online Diagnostics
Purpose
Displays the online diagnostics test results.
Displays the online diagnostics test results.
Displays the online diagnostics test schedule.
Displays the POST results. (The output is the
same as the show post command output.)
Displays diagnostic events such as error,
information, or warning based on the test
result.
Displays the short description of the results
from an individual test or all the tests.
175