Adjusting The Valve Clearance - Yamaha MX360 Service Manual
Hide thumbs
Also See for MX360:
- Supplementary service manual (32 pages) ,
- Service manual (178 pages) ,
- Owner's manual (140 pages)
Table of Contents
Advertisement
1
2
PERIODIC MAINTENANCE
3
4
5
ADJUSTING THE VALVE CLEARANCE
1. Remove:
9 Spark plug cap 1
9 Spark plug 2
NOTICE
Before removing the spark plug, use com-
pressed air to clean the cylinder head
cover to prevent dirt from falling into the
engine.
2. Remove:
9 Breather hose 3
9 Air filter case stay 4
9 Cylinder head cover 5
9 Cylinder head cover gasket
3. Pull the recoil starter slowly, and then set
the piston at TDC (top-dead-center) on
the compression stroke.
TIP
Check the piston position by inserting a screw
driver into the spark plug hole.
4. Measure:
9 Valve clearance
(Between the rocker arm and valve
stem end)
Out of specification → Adjust.
TIP
Valve clearance must be measured when the
engine has cooled down enough to be
touched.
Feeler gauge set:
YU-26900-9
Thickness gauge:
90890-03180
2-12
CHK
ADJ
Advertisement
Table of Contents
