Table of Contents
Advertisement
Managing the Switch
Caution
Reloading a module disrupts traffic through the module.
Step 1
Enter the configure terminal command to enter the configuration terminal mode.
Example:
configure terminal
switch#
switch(config)#
Step 2
Specify the slot number for the module that you are resetting by entering the reload module slot_numbercommand.
Example:
switch(config)#
Rebooting the Switch
To reboot or reload the switch, use the reload command without any options. When you use this command,
you reboot the switch.
Note
If you need to use the reload command, be sure to save the running configuration by using the copy
running-config startup-config vdc-all command beforehand.
Step 1
Start the configuration mode by entering the configure terminal command.
Example:
configure terminal
switch#
switch(config)#
Step 2
Save the running configuration by entering the copy running-config startup-config vdc-all command.
Example:
switch(config)#
Step 3
Reload the switch by entering the reload command.
Example:
switch(config)#
OL-30452-01.
reload module 1
copy running-config startup-config vdc-all
reload
Cisco Nexus 7710 Switch Site Preparation and Hardware Installation Guide
Rebooting the Switch
61
Advertisement
Table of Contents
