Cisco Firepower 2100 Series Hardware Installation Manual page 79

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Maintenance and Upgrade

b) Plug the snapping portion of the tie wrap into the hexagonal hole.

c) With the clamp side facing up, push the tie wrap in until it is fully engaged.

Make sure you have the correct location because you cannot remove the tie wrap from the power supply

Caution

module once you have installed it without damaging the tie wrap.

Figure 54: Connect the Tie Wrap

Tie wrap

Step 3

Secure the clamp:

a) Plug in the power supply power cord and wrap the clamp around the over mold portion of the power cord.

b) Squeeze the clamp ends together to the power supply so that the annular teeth engage with the mate on the clamp.

c) Make sure the clamp fits snugly into the over mold.

d) Adjust the clamp position on the tie wrap so that the clamp is tight against the front of the over mold and the power

cord cannot be removed by lightly pulling on it.

Secure the Power Cord on the Power Supply Module

Hexagonal hole

Cisco Firepower 2100 Series Hardware Installation Guide

Table of Contents

Show Quick Links

Table of Contents

Firepower 2110 Firepower 2120 Firepower 2130 Firepower 2140