Remove And Replace The Ssd - Cisco Firepower 2100 Series Hardware Installation Manual

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Remove and Replace the SSD

Figure 47: Remove the Network Module

If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;

otherwise, install another network module.

Step 4

To replace a network module, hold the network module in front of the network module slot on the right of the chassis

and pull the network module handle out.

Step 5

Slide the network module into the slot and push it firmly into place until the handle is flush with the front of the network

module.

Step 6

Tighten the captive screw on the lower left side of the network module.

Step 7

Power on the chassis so that the new network module is recognized.

What to do next

Follow the procedures in the

it has been discovered correctly by the security appliance.

Remove and Replace the SSD

Take note of the following warnings:

Warning

Statement 1030 Equipment Installation

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Cisco Firepower 2100 Series Hardware Installation Guide

FXOS configuration guide

to connect to the network module and make sure that

Maintenance and Upgrade

Table of Contents

Show Quick Links

Table of Contents

Firepower 2110 Firepower 2120 Firepower 2130 Firepower 2140