Network Modules
Note
For More Information
• See
• See
• See
• See
• See
Network Modules
The Firepower 2130 and 2140 contain one network module slot that provides optical or electrical network
interfaces. Network modules are optional, removable I/O modules that provide either additional ports or
different interface types. The Firepower network module plugs into the chassis on the front panel.
For More Information
• See
• See
• See
• See
10-Gb Network Module
The following figure shows the front panel of the 10-Gb network module (FPR2K-NM-8X10G). The
FPR2K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Note
Make sure you have the correct firmware package and software version installed to support this network
module.
Note
The FPR2K-NM-8X10G is NEBS-compliant.
Cisco Firepower 2100 Series Hardware Installation Guide
16
After removing power from the chassis by unplugging the power cord, wait at least 10 seconds before
turning power back ON.
Remove and Replace the Power Supply Module, on page 68
replacing the power supply module in the Firepower 2130 and 2140.
Remove and Replace the Fan Tray, on page 76
fan tray in the Firepower 2130 and 2140.
Ground the Chassis, on page 62
Power Supply Modules, on page 23
Front Panel LEDs, on page 10
10-Gb Network Module, on page 16
1-Gb Network Module, on page 17
Supported SFP/SFP+ Transceivers, on page 27
Remove and Replace the Network Module, on page 65
network modules.
for the procedure for removing and replacing the
for the procedure for using the grounding lug to ground the chassis.
for a description of the power supply module LEDs.
for a description of the fan LEDs.
for a description of the 10-Gb network module.
for a description of the 1-Gb network module.
for a list of supported SFPS.
for the procedure for removing and replacing
Overview
for the procedure for removing and