Cisco Firepower 2100 Series Hardware Installation Manual page 55
Hide thumbs
Also See for Firepower 2100 Series:
- Getting started manual (104 pages) ,
- Hardware installation manual (92 pages) ,
- Manual (12 pages)
Table of Contents
Advertisement
Mount the Chassis
Warning
Statement 1024 Ground Conductor
This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Warning
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073 No User-Serviceable Parts
No serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1047—Overheating Prevention
To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of: 40°C.
This procedure describes how to install the Firepower 2100 series in a rack using slide rails. It applies to all
models of the 2100 series. It ships with the Firepower 2130 and 2140 chassis; it is optional for the 2110 and
2120. For the 2110 and 2120, you install three screws on the chassis to secure the slide rail. For the 2130 and
2140, you use the pegs on the chassis to secure the slide rail. See
of the PIDs associated with racking the chassis.
You can install the optional cable management bracket on all models of the 2100 series. The optional cable
management bracket kit comes with two cable management brackets and four 8-32 x 0.375-in. screws.
Before you begin
You need the following to install the Firepower 2100 in a rack (4-post EIA-310-D rack) using slide rails:
• Phillips head screwdriver
• One slide rail kit that contains the following:
• (Optional) Two cable management brackets with four 8-32 x 0.375-in. screws
Note
The slide rail kit ships with the Firepower 2130/2140. You can order it for the
Firepower 2110/2120.
• Left and right slides rails with two M3x6 mm wafer-head screws
• Two slide rail locking brackets with six 8-32 x .25-in. screws
Rack-Mount the Chassis Using Slide Rails
Product ID Numbers, on page 31
Cisco Firepower 2100 Series Hardware Installation Guide
for a list
51
Hide quick links:
Advertisement
Table of Contents
