Cisco Firepower 2100 Series Hardware Installation Manual page 32
Hide thumbs
Also See for Firepower 2100 Series:
- Getting started manual (104 pages) ,
- Hardware installation manual (92 pages) ,
- Manual (12 pages)
Table of Contents
Advertisement
Supported SFP/SFP+ Transceivers
Figure 16: SFP Transceiver
1
Dust plug
3
Receive optical bore
Warning
Use appropriate ESD procedures when inserting the transceiver. Avoid touching the contacts at the rear, and
keep the contacts and ports free of dust and dirt. Keep unused transceivers in the ESD packing that they were
shipped in.
Note
The 1-Gb transceivers are limited to 1-GB operation only (no auto-negotiation support). 100-M/10-M modes
are not supported.
Caution
Although non-Cisco SFPs are allowed, we do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any interoperability problems that result from
using an untested third-party SFP transceiver.
The following table lists the supported transceivers.
Table 7: Supported SFPs
Optics Type
SFP 1Gb
Cisco Firepower 2100 Series Hardware Installation Guide
28
2
Bail clasp
4
Transmit optical bore
PID
Ports Supported
Overview
Hide quick links:
Advertisement
Table of Contents
