Table of Contents
Advertisement
Special Tools
Order special tools from your Toro Distributor.
Rear Roller Bearing and Seal Installation Tools
These tools are used to assemble the cutting deck rear
roller.
Toro Part Numbers:
Inner Seal Tool
Bearing/Outer Seal Tool
Bearing Installation Washer
Front Roller Bearing Installation Tool
The front roller bearing installation tool should be used
when installing bearings into the front rollers. This tool
presses equally against both the inner and outer bearing
races to ensure that no side load is applied to the bear-
ings during installation into the front rollers.
Toro Part Number: TOR6018
Spindle Plug
The spindle plug can be used to prevent contaminant
entry into the cutting deck spindle assembly when the
hydraulic motor is removed from the spindle.
Toro Part Number: 94−2703
Groundsmaster 3500
115−0852
115−0853
107−8133
Page 8 − 5
Inner Seal
Bearing/Outer Seal
Tool
Bearing Installation
Washer
Figure 1
Figure 2
Figure 3
Tool
Cutting Decks
Advertisement
Chapters
Table of Contents
Troubleshooting
