Cisco Catalyst 3560-X Command Reference Manual page 439

Hide thumbs Also See for Catalyst 3560-X:

Table of Contents

Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

Related Commands

Downloaded from

www.Manualslib.com

This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a

security device that supports IEEE 802.1Q encapsulation. Egress traffic replicates the source; ingress

traffic uses IEEE 802.1Q encapsulation.

Switch(config)# monitor session 2 destination interface gigabitethernet1/0/2 encapsulation

dot1q ingress dot1q vlan 5

This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a

security device that does not support encapsulation. Egress traffic and ingress traffic are untagged.

Switch(config)# monitor session 2 destination interface gigabitethernet1/0/2 ingress

untagged vlan 5

You can verify your settings by entering the show monitor privileged EXEC command. You can display

SPAN, RSPAN, FSPAN, and FRSPAN configuration on the switch by entering the show running-config

privileged EXEC command. SPAN information appears near the end of the output.

show monitor

show running-config

manuals search engine

Configures an RSPAN VLAN in vlan configuration mode.

Displays SPAN and RSPAN session information.

Displays the operating configuration. For syntax information, use

this link to the Cisco IOS Release 12.2 Command Reference listing

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_co

mmand_reference_list.html

Select the Cisco IOS Commands Master List, Release 12.2 to

navigate to the command.

Catalyst 3750-X and 3560-X Switch Command Reference

monitor session

Catalyst 3750-x