Cisco 7962G User Manual page 36
Unified ip phone unified communications manager 6.0 (sccp and sip)
Hide thumbs
Also See for 7962G:
- Administration manual (235 pages) ,
- User manual (110 pages) ,
- Specifications (5 pages)
Table of Contents
Advertisement
If you want to...
Get an updated list of
participants
See who started the
conference
Remove any conference
participant
Drop the last party added to
the conference
End your participation in a
conference
Join together two standard
conferences on the same line
Verify that a conference call is
secure
Remove a non-secure
participant from a conference
Tips
• Calls must be on the same line before you can add them to a conference. If calls are on different
lines, transfer them to a single line before using Confrn, Conference ,or Join. (Join is on SCCP
phones only.)
• Depending on how your phone is configured, if you leave a conference after initiating it, the
conference might end. To avoid this, transfer the conference before hanging up.
• To start a secure conference, you must use a phone configured with security.
• Non-secure conferences and participants display a
28
Then...
While viewing the conference list, press Update.
While viewing the conference list, locate the person listed at the
bottom of the list with an asterisk (*) next to the name.
1. Highlight the participant's name.
2. Press Remove.
Press Remove Last Participant
Hang up or press EndCall.
On SCCP phones, use the Join or DirTrfr softkeys.
On SIP phones, use the Confrn or Transfer softkeys.
Check with your system administrator to see if this feature is
available to you.
Look for the
or
screen.
While viewing the Conference List, locate the participant without the
or
icon, and press Remove.
Check with your system administrator to see if non-initiators of a
conference can remove participants.
or RmLstC.
icon after "Conference" on the phone
icon.
OL-12644-01
Advertisement
Table of Contents
