Table of Contents
Advertisement
▀ Configuring the System as a Standalone eGTP P-GW
The retransmission-timeout command works in conjunction with
DHCP Service Configuration Verification
Step 1
Verify that your DHCP servers configured properly by entering the following command in Exec Mode:
show dhcp service all
This command produces an output similar to that displayed below where DHCP name is
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
130
Service name:
Context:
Bind:
Local IP Address:
Next Hop Address:
MPLS-label:
Input:
Output:
Service Status:
Retransmission Timeout:
Max Retransmissions:
Lease Time:
Minimum Lease Duration:
Maximum Lease Duration:
DHCP Dead Time:
DHCP Dead consecutive Failure:5
DHCP T1 Threshold Timer:
DHCP T2 Threshold Timer:
DHCP Client Identifier:
DHCP Algorithm:
DHCP Servers configured:
Address: 150.150.150.150
DHCP server rapid-commit: disabled
max-retransmissions
dhcp1
isp
Done
150.150.150.150
192.179.91.3
5000
1566
1899
Started
3000 (milli-secs)
2
600 (secs)
600 (secs)
86400 (secs)
120 (secs)
50
88
Not Used
Round Robin
Priority: 1
PDN Gateway Configuration
command.
:
dhcp1
Advertisement
Table of Contents
