Table of Contents
Advertisement
PDN Gateway Configuration
Required
Description
Information
Remote access
The type of remote access that will be used to access the system such as telnetd, sshd, and/or ftpd.
type(s)
Required P-GW Context Configuration Information
The following table lists the information that is required to configure the P-GW context on a P-GW.
Table 10.
Required
Description
Information
P-GW context
An identification string from 1 to 79 characters (alpha and/or numeric) by which the P-GW context will be
name
recognized by the system.
Accounting
An identification string from 1 to 63 characters (alpha and/or numeric) by which the accounting policy will be
policy name
recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
S5/S8 Interface Configuration (To/from S-GW)
Interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface will be
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and
IPv4 or IPv6 addresses assigned to the interface.
subnet
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port
The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
number
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP
Used when configuring static IP routes from the interface(s) to a specific network.
address
GTP-U Service Configuration
GTP-U service
An identification string from 1 to 63 characters (alpha and/or numeric) by which the GTP-U service will be
name
recognized by the system.
IP address
S5/S8 interface IPv4 address.
P-GW Service Configuration
P-GW service
An identification string from 1 to 63 characters (alpha and/or numeric) by which the P-GW service will be
name
recognized by the system.
Multiple names are needed if multiple P-GW services will be used.
PLMN ID
MCC number: The mobile country code (MCC) portion of the PLMN's identifier (an integer value between
100 and 999).
MNC number: The mobile network code (MNC) portion of the PLMN's identifier (a 2 or 3 digit integer value
between 00 and 999).
Required Information for P-GW Context Configuration
Configuring the System as a Standalone eGTP P-GW ▀
Cisco ASR 5x00 Packet Data Network Gateway Administration Guide ▄
107
Advertisement
Table of Contents
