Changing The Access Point/Bridge Output Power - Cisco Aironet 1300 Series Hardware Installation Manual
Outdoor access point/bridge
Hide thumbs
Also See for Aironet 1300 Series:
- Installation manual (124 pages) ,
- Quick start manual (35 pages) ,
- Hardware installation manual (118 pages)
Table of Contents
Advertisement
Maximum Power Levels and Antenna Gains
Table D-2
Regulatory Domain
Japan (-J)
(10 mW/MHz EIRP maximum)
1. A minimum of 2 dBi cable loss must be be used for this configuration.
Changing the Access Point/Bridge Output Power
This section provides instructions for changing the access point/bridge output power to comply with the
maximum power limits imposed by regulatory domains (see
Gains" section on page
browser:
Administrator privileges may be required in order to change access point/bridge settings.
Note
To meet regulatory restrictions, the external antenna access point/bridge unit and the external antenna
Note
must be professionally installed. The network administration or other IT professional responsible for
installing and configuring the unit is a suitable professional installer. Following installation, access to the
unit should be password protected by the network administrator to maintain regulatory compliance.
Open your Internet browser.
Step 1
Enter the access point/bridge IP address in the browser address or location line and press Enter. An Enter
Step 2
Network Password screen appears.
Enter your username (default Cisco) in the User Name field.
Step 3
Enter the access point/bridge password (default Cisco) in the Password field and press Enter. The
Step 4
Summary Status page appears.
Click Network Interfaces and the network interface menu appears.
Step 5
Click Radio0-802.11G and the 802.11G Status screen appears.
Step 6
Step 7
Click the Settings tab and the settings screen appears.
Step 8
On the CCK Transmit Power (mW) setting, select the maximum CCK power allowed for your antenna in
your regulatory region.
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
D-4
Maximum Power Levels Per Antenna Gain for IEEE 802.11g (continued)
Antenna Gain (dBi)
13 (Integrated patch)
D-3). Follow these instructions to change the output power settings using your
Appendix D
Maximum Power Level (mW)
5.2 (Omni)
9 (Patch)
10 (Yagi)
11 (Omni)
12 (Omni)
13.5 (Yagi)
14 (Sector)
21 (Dish)
"Maximum Power Levels and Antenna
Channels and Antenna Settings
CCK
OFDM
10
10
10
10
10
10
10
10
10
10
10
10
10
10
10
10
10
10
OL-5048-02
Hide quick links:
Advertisement
Chapters
Table of Contents
