hit counter script
  1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Wireless Access Point
  5. Aironet 1300 Series
  6. Hardware installation manual

Cisco Aironet 1300 Series Hardware Installation Manual page 83

Outdoor access point/bridge
Hide thumbs Also See for Aironet 1300 Series:
Table of Contents

Advertisement

Chapter 7
Troubleshooting
Table 7-1
LED Indications (continued)
Ethernet
Status
LED
LED
—
Blinking
green
—
Green
—
Blinking
amber
—
Amber
Red
Amber
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
1. Preconfigured bridges search indefinitely.
The access point/bridge uses a blinking code to identify various error conditions. The code sequence uses
a two-digit diagnostic code that starts with a long pause to delimit the code, followed by the LED
flashing red to count out the first digit, then a short pause, followed by the LED flashing red to count out
the second digit.
OL-5048-02
Radio
Install
Meaning
LED
LED
—
—
Root bridge mode—no remote bridges are associated.
Non-root bridge mode—not associated to the root bridge.
If all bridges are powered up, this could be caused by incorrect SSID
and security settings or improper antenna alignment. You should check
the SSID and security settings of all bridges and verify antenna
alignment.
If the problem continues, contact technical support for assistance.
—
—
Root mode—associated to at least one remote bridge.
Non-root mode—associated to the root bridge.
This is normal operation.
—
—
General warning—disconnect and reconnect the power injector power
jack. If the problem continues, contact technical support for
assistance.
—
—
Loading firmware.
Red
—
Loading Firmware error—disconnect and reconnect the power injector
power. If the problem continues, contact technical support for
assistance.
Off
—
Normal operation.
Blinking
—
Transmitting and receiving radio packets—normal operation.
green
Blinking
—
Maximum retries or buffer full occurred on the radio
amber
interface—disconnect and reconnect the power injector power jack. If
the problem continues, contact technical support for assistance.
Amber
—
Radio firmware error—disconnect and reconnect power injector
power. If the problem continues, contact technical support for
assistance.
—
Amber
Not associated (non-root mode). The access point/bridge attempts to
blinking
associate with a root bridge for 60 seconds
—
Amber
Associated (non-root mode).
—
Green
Not associated (root mode). The access point/bridge attempts to
blinking
associate with a non-root bridge indefinitely.
—
Green
Associated (root mode).
—
Red
Overcurrent or overvoltage error—disconnect power to the power
injector, check all coax cable connections, wait approximately 1
minute, and reconnect power. If error continues, contact technical
support.
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
Checking the LEDs
1
.
7-3

Advertisement

Chapters

Table of Contents
loading

Related Manuals for Cisco Aironet 1300 Series

Related Products for Cisco Aironet 1300 Series

This manual is also suitable for:

Air-br1310g-a-k9Air-br1310g-a-k9-r

Table of Contents