Assigning Basic Settings
•
Click Apply to save your settings. If you changed the IP address, you lose your connection to the access
Step 6
point/bridge. Browse to the new IP address to reconnect to the access point/bridge.
Default Settings on the Express Setup Page
Table 5-1
Table 5-1
Parameter
System Name or
Host Name
Configuration Server
Protocol
IP Address
IP Subnet Mask
Default Gateway
SNMP
Role in Radio Network
Optimize Radio Network
for
1. After a static IP address is assigned or the role is changed from Install, the SSID is automatically changed to tsunami.
2. If an access point/bridge running Cisco IOS Release 12.3(2)JA2 or later software with a default configuration does not receive
3. During install mode, the SSID is autoinstall.
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
5-8
Aironet Extensions—Enable this setting if there are only Cisco Aironet devices on your wireless
LAN and the unit is operating as an access point or workgroup bridge.
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
Default Setting
Cisco IOS Release 12.2(15)JA
bridge
DHCP
Assigned by DHCP
setting); if DHCP is disabled, the
default setting is 10.0.0.1
Assigned by DHCP (default setting);
if DHCP is disabled, the default
setting is 255.255.255.224
Assigned by DHCP (default setting);
if DHCP is disabled, the default
setting is 0.0.0.0
defaultCommunity
Read Only
Install mode
Throughput
an IP address from your DHCP server, it continues to send DHCP requests indefinitely.
Chapter 5
Configuring the Access Point/Bridge for the First Time
Cisco IOS Release 12.3(2)JA2 or
later
ap
DHCP
1
(default
Assigned by DHCP by default
Assigned by DHCP by default
Assigned by DHCP by default
defaultCommunity
3
Access point (root)
Throughput
Read Only
2
OL-5048-02