Debug Dot1X - Cisco Catalyst 3750 Command Reference Manual
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
debug dot1x
debug dot1x
Use the debug dot1x privileged EXEC command to enable debugging of the 802.1x feature. Use the no
form of this command to disable debugging output.
Syntax Description
all
errors
events
packets
registry
state-machine
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.1(11)AX
12.1(14)EA1
Usage Guidelines
The undebug dot1x command is the same as the no debug dot1x command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands
Command
show debugging
show dot1x
Catalyst 3750 Switch Command Reference
B-6
debug dot1x {all | errors | events | packets | registry | state-machine}
no debug dot1x {all | errors | events | packets | registry | state-machine}
Display all 802.1x debug messages.
Display 802.1x error debug messages.
Display 802.1x event debug messages.
Display 802.1x packet debug messages.
Display 802.1x registry invocation debug messages.
Display state-machine related-events debug messages.
Modification
This command was introduced.
The authsm, backend, besm, core, and reauthsm keywords were removed.
The errors, events, packets registry, and state-machine keywords were
added.
Description
Displays information about the types of debugging that are enabled. For
syntax information, refer to the Cisco IOS Release 12.2 Configuration
Guides and Command References > Cisco IOS Configuration
Fundamentals Configuration Guide, Release 12.2 > System Management
> Troubleshooting and Fault Management.
Displays 802.1x statistics, administrative status, and operational status for
the switch or for the specified port.
Appendix B
Catalyst 3750 Switch Debug Commands
78-16181-01
- Quick Links:
- Boot System
Hide quick links:
Advertisement
Table of Contents
