Configuring Automatic Configuration (Dhcp); Configuring Pppoe - Cisco CVR100W Administration Manual
Wireless-n vpn router
Hide thumbs
Also See for CVR100W:
- Administration manual (131 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
Configuring Network
Configuring WAN Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
Cisco CVR100W Wireless-N VPN Router Administration Guide
Configuring Automatic Configuration (DHCP)
If your Internet Service Provider (ISP) uses the Dynamic Host Control Protocol
(DHCP) to assign you an IP address, you will receive a dynamic IP address that is
newly generated each time you log in.
To configure the DHCP settings:
Choose Networking > WAN > Internet Setup.
From the Internet Connection Type drop-down menu, choose Automatic
Configuration - DHCP.
(Optional) To configure other optional settings, see
Settings.
Click Save.
Configuring PPPoE
To configure the PPPoE settings:
Choose Networking > WAN > Internet Setup.
From the Internet Connection Type drop-down menu, choose PPPoE.
In the PPPoE Settings area, enter the following information (you may need to
contact your ISP to obtain your PPPoE login information):
Username
Password
Connect on Demand
Enter your username assigned to you by the ISP.
Enter your password assigned to you by the ISP.
Select this option if your ISP charges based on the
amount of time that you are connected. When you
select this option, the Internet connection is on only
when traffic is present. If the connection is idle—that
is, no traffic is flowing—the connection is closed. If you
click Connect on Demand, enter the number of
minutes after which the connection shuts off in the
Max Idle Time field.
Configuring Optional
3
39
- Quick Links:
- Lan Ethernet Interface
Hide quick links:
Advertisement
Table of Contents
