Table of Contents
Advertisement
General PXM1E Configuration Procedures
Table 3-15 cnfilmi Command Configuration Parameters (continued)
Parameter
vci
ilmiTrapEnable
keepAliveInt
pollingIntervalT491
pollInctFact
Step 4
To confirm your configuration changes, enter the dspilmis command.
Configuring ILMI Automatic Configuration
The Cisco MGX 8850 (PXM1E) and Cisco MGX 8830 switches support the automatic configuration
feature of ILMI 4.0, which allows two devices that share a link to share their configurations and negotiate
a common set of communication parameters. For example, if two network devices share a link and are
configured for different maximum VCIs on a partition, the automatic configuration feature can
determine and select the highest common VCI supported by both nodes. To use ILMI automatic
configuration, the devices at each end of the link must support this ILMI 4.0 feature.
To enable or disable automatic configuration on a port, enter the cnfautocnf command as described in
the following procedure.
A link between two nodes will not operate correctly if the ILMI automatic configuration feature is
Note
enabled at one end and disabled at the other.
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
3-62
Description
ILMI signaling VCI. If you need to change the default, enter a VCI number in
the range of 0 to 65535. Note that changing this value disables ILMI
communications until the device at the remote end of the line has been
configured for the same ILMI VCI.
Default = 16.
ILMI trap distribution. When ILMI is started on a port, ILMI traps are sent to
SNMP managers such as CWM.
To enable or disable the distribution of ILMI traps, enter 1 to enable ILMI traps
or 2 to disable ILMI traps.
Default = 1 (enable).
ILMI keep alive timer.
Range: 1 to 255.
Default = 1.
ILMI polling interval T491 timer.
Range: 0 to 255.
Default = 5.
Note
0 = no polling
ILMI polling factor K.
Range: 0 to 65535.
Default = 4.
Chapter 3
Provisioning PXM1E Communication Links
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Advertisement
Table of Contents
Troubleshooting
