Table of Contents
Advertisement
Fig. 44 Setting of Cut Paper Sheet
NOTES: 1. The Paper End Detector function may be disabled under
software control (ESC 8; refer to page 66 provided printing is
left off within 7.5 mm from the paper bottom edge).
2. If the paper is set on the line marked 1/4 as shown in Fig. 44,
then the printing starts from a position 28.6 mm below the top
edge of the paper. If the paper is set on the line marked 1/8,
then the printing starts from a position 30.2 mm below the top
edge of the paper.
8. Push the scale back into position and put the printer lid on the Printer. (See
Fig. 45)
Fig. 45 Printer with Cut Paper Sheet Set Completely
- 3 3 -
Advertisement
Table of Contents
