Default Settings For San Port Channels - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual
Cli software configuration guide
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Command reference manual (792 pages)
Table of Contents
Advertisement
Configuring SAN Port Channels
Autocreated SAN port channels are indicated explicitly to help differentiate them from the manually created
SAN port channels. The following example shows how to display an autocreated port channel:
switch# show interface fc2/1
fc2/1 is trunking
Belongs to port-channel 123
...
Default Settings for SAN Port Channels
The table below lists the default settings for SAN port channels.
Table 72: Default SAN Port Channel Parameters
Parameters
Port channels
Create port channel
Default port channel mode
Autocreation
OL-16597-01
Hardware is Fibre Channel, FCOT is short wave laser
Port WWN is 20:0a:00:0b:5f:3b:fe:80
...
Receive data field Size is 2112
Beacon is turned off
Port-channel auto creation is enabled
Default
FSPF is enabled by default.
Administratively up.
On.
Disabled.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Default Settings for SAN Port Channels
529
Advertisement
Chapters
Table of Contents
Troubleshooting
