Forcing Fabric Binding Activation; Copying Fabric Binding Configurations; Clearing The Fabric Binding Statistics - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual
Cli software configuration guide
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Command reference manual (792 pages)
Table of Contents
Advertisement
Configuring Fabric Binding
Forcing Fabric Binding Activation
If the database activation is rejected due to one or more conflicts listed in the previous section, you may decide
to proceed with the activation by using the force option.
To forcefully activate the fabric binding database, perform this task:
Procedure
Step 1
Step 2
Step 3
Copying Fabric Binding Configurations
When you copy the fabric binding configuration, the config database is saved to the running configuration.
You can use the following commands to copy to the config database:
• Use the fabric-binding database copy vsan command to copy from the active database to the config
• Use the fabric-binding database diff active vsan command to view the differences between the active
• Use the fabric-binding database diff config vsan command to obtain information on the differences
• Use the copy running-config startup-config command to save the running configuration to the startup
Clearing the Fabric Binding Statistics
Use the clear fabric-binding statistics command to clear all existing statistics from the fabric binding database
for a specified VSAN.
switch# clear fabric-binding statistics vsan 1
OL-16597-01
Command or Action
switch# configuration terminal
switch(config)# fabric-binding activate
vsan vsan-id force
switch(config)# no fabric-binding
activate vsan vsan-id force
database. If the configured database is empty, this command is not accepted.
switch# fabric-binding database copy vsan 1
database and the config database. This command can be used when resolving conflicts.
switch# fabric-binding database diff active vsan 1
between the config database and the active database.
switch# fabric-binding database diff config vsan 1
configuration so that the fabric binding config database is available after a reboot.
switch# copy running-config startup-config
Purpose
Enters configuration mode.
Activates the fabric binding database for the
specified VSAN forcefully, even if the
configuration is not acceptable.
Reverts to the previously configured state or to the
factory default (if no state is configured).
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Forcing Fabric Binding Activation
657
Advertisement
Chapters
Table of Contents
Troubleshooting
