Server - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual
Cli software configuration guide
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Command reference manual (792 pages)
Table of Contents
Advertisement
Configuring RADIUS
Step 3
Step 4
Step 5
Step 6
Configuring the RADIUS Transmission Retry Count and Timeout Interval for a Server
By default, a Cisco Nexus 5000 Series switch retries transmission to a RADIUS server only once before
reverting to local authentication. You can increase this number up to a maximum of five retries per server.
You can also set a timeout interval that the switch waits for responses from RADIUS servers before declaring
a timeout failure.
To configure RADIUS transmission retry count and timeout interval for a server, perform this task:
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
OL-16597-01
Configuring the RADIUS Transmission Retry Count and Timeout Interval for a Server
Command or Action
switch(config)# radius-server timeout
seconds
switch(config)# exit
switch# show radius-server
switch# copy running-config
startup-config
Command or Action
switch# configure terminal
#switch(config)# radius-server host
{ipv4-address |ipv6-address |
host-name} retransmit count
switch(config)# switch(config)#
radius-server host {ipv4-address
|ipv6-address | host-name} timeout
seconds
switch(config)# exit
switch# show radius-server
switch# copy running-config
startup-config
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Purpose
Specifies the transmission timeout interval for
RADIUS servers. The default timeout interval is 5
seconds and the range is from 1 to 60 seconds.
Exits configuration mode.
(Optional)
Displays the RADIUS server configuration.
(Optional)
Copies the running configuration to the startup
configuration.
Purpose
Enters configuration mode.
Specifies the retransmission count for a specific server.
The default is the global value.
The retransmission count value specified for
Note
a RADIUS server overrides the count
specified for all RADIUS servers.
Specifies the transmission timeout interval for a
specific server. The default is the global value.
Note
The timeout interval value specified for a
RADIUS server overrides the interval value
specified for all RADIUS servers.
Exits configuration mode.
(Optional)
Displays the RADIUS server configuration.
(Optional)
Copies the running configuration to the startup
configuration.
249
Advertisement
Chapters
Table of Contents
Troubleshooting
