Configuring Fibre Channel Interfaces; Information About Fibre Channel Interfaces; Licensing Requirements For Fibre Channel; Physical Fibre Channel Interfaces - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Cli software configuration guide

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Configuring Fibre Channel Interfaces

This chapter contains the following sections:

Configuring Fibre Channel Interfaces

On Cisco Nexus 5000 Series switches, Fibre Channel capability is included in the Storage Protocol Services

Ensure that you have the correct license installed (N5010SS or N5020SS) before using Fibre Channel interfaces

and capabilities.

You can configure virtual Fibre Channel interfaces without a Storage Protocol Services license, but these

interfaces will not become operational until the license is activated.

Cisco Nexus 5000 Series switches provide up to sixteen physical Fibre Channel uplinks. The Fibre Channel

interfaces are supported on optional expansion modules. The Fibre Channel expansion module contains eight

Fibre Channel interfaces. The Fibre Channel plus Ethernet expansion module contains four Fibre Channel

Each Fibre Channel port can be used as a downlink (connected to a server) or as an uplink (connected to the

data center SAN network). The Fibre Channel interfaces support the following modes: F, NP, E, TE, and SD.

Configuring Fibre Channel Interfaces, page 461

C H A P T E R

Cisco Nexus 5000 Series Switch CLI Software Configuration Guide

Table of Contents